Purchased Pro X and it took me a while but finally learned how to do the embossing, then send it to the CAD side and generated the CAM codes for milling. Here's my problem-every time I try and run the program which contains about 43,000 lines of code I get a "path offset wrong ending on line #" I've tried running various codes using different step over dimensions and each time I get this error message on a line in the code. I even went back and made sure that all the tool paths were going the same direction, still same error message. anyone have any suggestions as to the cause of this error? I'm running BobCad v20.7 with a Heidenhain 155b controller on a BP series II interact 4 machine. I'm also running the dnc4u software to drip feed the codes to the Heidenhain.

Ben