does anybody know where i could grab some straight shank er25 holder that are 5/8 all those that i find are 3/4 or 1

i machined 30 int ones down just make shure they're not hardened first :-)

mike

no i dont have any and would like to know if it exist i dont have a lathe in my disposition

Hi ataxy
Im not sure this will help; But this company has good prices and alot of stuff.
Call them or look online. www.Shars.com Phone 800-718-3544
Ask for a catalog. I got my ENCO Mill Table from them. And they are honest.
Can't say that about alot of people now days.

humm unfortunate most of there website is unavailable and under construction

They don't have one in 5/8, but do have one in 1/2"

http://www.usshoptools.com/current_year/all_products/all_products.asp#straightshanks

Usual disclaimer

oh goodie that would work i think i just have to check if the lenght is not to long at 4in but i am sure it will work

I have one for my mill/drill and several times, I have had the thought to cut it down in length! You might have to use a "friction wheel" as I do not remember if it is hardened or not.

ok thx