Have been trying to establish the connection betweeen my laptop and my tnc 370 with no success.
Settings I am using on tncremont are serial connection, com3 and automatic baud rate.
Then i have the nc set into EXT mode.
Simply cannot get a connection established.
Has anyone any ideas of what i may be doing wrong?
Thanks in advance,

hi mate i had a few hassels when i tried conecting my laptop to my bridgeport with heidenhain 2500 control im not sure about your control but i know the cable conection was very important along with a few parrameter changes regards greg

What errors are you getting?

have you tried tncserver within tnc remote?