I need format info for an OSP5020M.
We are integrating a Tool Presetter into our network and plan on sending tool offset data from the presetter to a file on our network to be dumped into our CNC's.
I've gotten good results on our Fanuc controls but, have no clue on the Okuma controls.
What gcode syntax would I use to write a program that sets hgt. and dia. offsets?
Happy Friday!

Try outputting the offsets from the CNC to the PC. That should give you the format.

Tool offsets are just another "System Variable" that can be both Read from and Written to.
To access the tool radius use VTOFD[x] where x represents the tool number.
To access the tool Length use VTOFH[x] where x also represents the tool number.
So a program might look like this (for 3 tools):
$TOOLDATA.MIN%
O1000
(SET TOOL 1 DATA)
VTOFH[1]=34.220
VTOFD[1]=10.010
(SET TOOL 4 DATA)
VTOFH[4]=-10.435
VTOFD[4]=0.000
(SET TOOL 15 DATA)
VTOFH[15]=156.012
VTOFD[15]=39.950
M2

Note in this example I am using Metric units, obviously the tool data will be in the correct unit for you anyway.
Once the presetter has the information formatted into a program as shown above, it should be a simple matter to load the program into your machine and run it.
The tool data will be updated instantly.
Hope this helps
Brian.
:)

Thanks everyone.
This should put me on the correct path.