I am working on an old piece of equipment made in 1923. It has 10/30 brass screws. Does anyone know where I can get a 10/03 x 7/8 round head brass screw? I did not know where to ask this question so I put it here.

Thanks

Vince

Got a small engine lathe capable of cutting threads?
Got any round or hex brass stock?
Got any idea where I'm going here?
Seriously, your best bet would be to just turn a few of them and put the extras in a drawer someplace. Odds are you'll need them sooner or later.

That's my last resort.

Vince