|
View Full Version : Can you make Thread? jimmychand 12-01-2007, 08:41 PM Can you make Thread? I have retrofit a CNC lathe with Mach 3. Now how can I make thread with Mach turning? I think it's not easy without servo spindle, isn't it? Jimmy SORCHEROR 12-01-2007, 09:03 PM you can only do threads with a spindle that is ac or dc motor with encoder on it,maybe with a stepper motor with encoder jimmychand 12-01-2007, 11:12 PM Basically you must know the exact location of the spindle right? I have an AC motor (not servo) with an encoder but i don't know how to do thread jim_geib 12-02-2007, 12:35 AM You need one sensor on yor spindle to trigger once per rev. It is shown in the manual. I have mine setup and have cut threads several times. There is a threading wizard (simple threading). jimmychand 12-02-2007, 06:32 AM Dear Jim geib First thank you for your reply, How do you set up your sensor? I am pretty new to this. Could you please teach me? I don't know how does the sensor work with Parrallel port. For example parralel port on my pin 12 always give 4.5V. So i am not sure how to connect them. Please help. Thank you :) alquicira 02-16-2008, 02:58 PM Dear Jiimmy chand You have to visit the page cnc4pc ad buy the index pulsce card, it come whit the sensaor that you have to mount whit one sloted disk on the spindle. Teyber 07-04-2008, 10:32 AM linky- http://www.cnc4pc.com/Store/osc/product_info.php?products_id=129 cnc_swe 07-24-2008, 03:45 PM Look at the picīs on this side. You can tread if you have an indexcard + spindle sheet metal. http://web.telia.com/~u33228040/ Dan |