Got the new version of Feature Cam loaded on my new comp yesterday. I did a simple program and all worked fine. I loaded a program that was saved on ver 13 and looked fine but did not run right. It picked up tool 22 instead of tool 18. 18 was the correct tool in the tool list. I checked the code and found something like this


N2545GOX1.25Y1.25
#1
N2555G
=#7

Is this do to an older version not compatible to new version or is it a post processor.

Mill is bridgeport TC3

Try making sure "disable macros" is checked in the post processor selection dialog box

also might mention that O looks like a letter not the number 0 ???
might be pulling in from the setup fixture ID

'If I can't make it it aint worth havin!"
Rick