Enclosure on a Eldorado Bridge mill. Got tired of cleaning coolant up and finding chips in the oddest places.
Made of angle aluminum and lexan
Warning large pictures.
http://www.rainman229.com/images/web/tools/enclose1.jpg
http://www.rainman229.com/images/web/tools/enclose2.jpg

Front section the panels slide out the top. The whole front section can easily be removed. Lift right off, leaving half of the side shields on. So i can still mess with it in manual if need. Plus makes it easier to clean the back area with it off.

Rainman

I put some FRP plastic on my back wall with a little drip edge on the bottom so the coolant goes into a sheet metal pan- In front I have a magnetic base with a lexan shield I can position in front of the cutting area.