Shepard
11-08-2007, 02:29 PM
Hello,
I've been trying to use Mach's Keyway wizard to cut a keyway but it won't give me the width. I ask it to cut a .26 keyway with a 1/8 endmill but gcode is constant in the y. So I end up with a 1/8 slot. Any help?
I've been trying to use Mach's Keyway wizard to cut a keyway but it won't give me the width. I ask it to cut a .26 keyway with a 1/8 endmill but gcode is constant in the y. So I end up with a 1/8 slot. Any help?