I Have a Okuma LSN-10 with an Allen Bradley 9-240 control. New about 1990. I have been told some company was buying Okuma lathes new and putting different controls on them. They are out of business.
I was given this lathe, because the battery went dead and the PAL ladder logic went away. I got the right AB software "ODS" off ebay, studied and wrote a very rudimentary ladder for this lathe. Got it minimally running, without the tool turrets working.
I sure would like to find someone that has one of these lathes with this control and copy it's ladder logic. I would travel anywhere in the USA to download this ladder logic, if necessary.
Thanks, Larry Reiss Omaha, Nebraska
reiss_machinist at yahoo dot com
four zero two two one eight three two eight eight