Can anyone point me in the right direction to find the dimensions for 37degree JIC/AN hydraulic fittings with the male flare on them. I need to know how wide the flare is, what diameter thread reliefs and such. Sizes #4 all the way to #20. Doing some custom auto racing work and dont know the dimensions for my lathe setup.

thanks,
aaron

You need to get in touch with someone in the military logistic system that can supply you with a copy of the original standard. Each P/N will have its own standard drawing listing the different dash numbers. The common union fitting with two male ends is AN815.
If no luck, I can measure some of the surplus fittings i have collected.

Regards
Lars

Aaron,
You can get AN drawings for $25 at: www.usmilitarydrawings.com

Best regards

Bruno

thanks! Thats exactly what I need. I just gotta sort threw the site. I hope its not $25 each. $150 in drawings I would need. #4,#6,#8,#10,#12, and #16.

You should not need to buy one for each size. All the standards I have seen contains all the dash sizes. Just decide on a part number.

Lars

Well, spent some time Googling and saved you the cash:-)
You should find what you are looking for in one of theese pages:
http://www.dscc.dla.mil/Programs/MilSpec/listdocs.asp?BasicDoc=MIL-F-18866
http://www.dscc.dla.mil/Programs/MilSpec/listdocs.asp?BasicDoc=MIL-F-5509
Or maybe this is the ultimate: http://assist.daps.dla.mil/docimages/A/0000/0004/1956/000000077235_000000123996_LLLRQMYLYT.PDF

Regards
Lars

DUDE YOU ARE THE MAN! Id send you a case of beer, but shipping to norway would cost more than the beer! THANK YOU SOO MUCH!

No problem, only glad to help.
Cheers, and have a nice weekend!

Lars