Chad,
How can I draw (or write in CAM) text that follows the contour of an ellipse. I have an engraving project with an ellipse.

Straight text and radial text is easy.



TIA

Rob,

What is your email? I will send instructions on how to do this.

Did them instructions I sent help?

Chad, I haven't had time to engrave the oval piece. I was about to start on it, but got a hot job to work on.

I hope to have the oval engraving finished later this week.


I'll keep you updated, but I'm sure it will work. Engraving is fun with Dolphin. :)

Chad, please re-send the engraved text aligned with an ellipse again. I couldn't open the video that you sent.


Thanks in advance. :)