Hello, I am new here:)

i just purchased a lathe, Wabeco D6000E, and I am going to have to run the Mach3 controler softwear from my laptop. Is this going to be difficult, a problem? I have no manual for the Mach3 softwear, anybody now where i can aquire one? Last question, can anybod running this tell me if I can use it as a digital read out in manual work?

Thanks, and sorry for the stupid questions, up front!
Jim Burke

You can download a manual at www.machsupport.com

Some laptops will not run Mach3, but the only way to know for sure is to try and see.