Hello people.
I have been considering buying me a "JD2 Model 3" bender for a while, but I think I will make one my self. What plans should I go for? And witch plans are most similar to the JD2 bender (http://www.jd2.com/)?

Is this a good bender? It can bend the same square and round tube that JD2 ca.

http://cgi.ebay.com/Air-Hyd-Tube-Bender-Plans-for-OD-to-2-OD-Tubing_W0QQitemZ290169374850QQihZ019QQcategoryZ11329QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

http://www.gottrikes.com/Tube_Bender.htm

Anyone with experiense that can give me an advice?

I have built the gotttrikes bender and it works great. Check out this thread here. bender thread (http://www.pirate4x4.com/forum/showthread.php?t=376183)