Ok guys, I bought the set of Solsylva plans a while back to build a cnc router. I upgraded almost everything and just before I started to build it I sold it all off to do another project that I cant even remember what is was anymore. Now I want to build another and finish it this time. I bought the belt and pullys from the place that was specified in the solsylva plans book. Since I do not want to buy the plans again and am going to build it on my own plans I need to know what the source was for the belt and pullys again. If you can please give me the name of the site and the part #'s I would appreciate it.

http://www.sdp-si.com


For the 25 x 37 dual leadscrew tabletop machine the parts are:

2 each Polycarbonate (XL) 15 teeth 0.313" bore Aluminum insert 2 flanges - p/n A 6Z 3-15DF03710

1 each Aluminum Alloy (XL) 15 teeth 0.250" bore no insert 2 flanges - p/n A 6A 3-15H3708

1 each Belt (XL) 414 teeth 3/8" width Neoprene w/fiberglass 82.80" - p/n A 6R 3-414037

If you are talking about the belt drive floor standing machine the parts will be very different.

CarveOne

I was referring to the bigger of the dual leadscrew design tables. Sorry I should have been specific. Is there a new design for a floorstanding unit?

The dual leadscrew table top routers shown in the current plans book are 17" x 20" and 25" x 37". I'm building the 25" x 37" version, and is the one the part numbers I posted are for.

There is a 27.5" x 64" belt drive table in the latest plans book. It is the red and white floor standing table shown on the Solsylva home page at http://www.solsylva.com/ and I suppose the legs could be shortened for use on a bench top. This machine uses belt drive on all steppers.

CarveOne