My dad spoke with a DT rep today, and he said the max sheet you could cut was 2" thick do to the design of the table.

So how does it do this?
http://www.dynatorch.com/images/THControl.mpg

=\

Any help?

EDIT: Looking at it again, maybe that is 2" but it seems a little bigger than that....

NoLimit,

I know more abut the software, however, for doing things like in the video would be the “Z” axis travel limit.

Sincerely
Independent CNC Programmer
Home Page: http://www.ctcn.net/~3kings

Ok, answered my question.

Thank you, I will probably be getting a DT pretty soon, a 6X12.

:)

You are slightly mistaken. The max material thickness you can cut THROUGH would be 2" With the height sensor control you can cut thinner material which is formed at different heights. I think they were talking about the actual thickness of cut not the formed height.