Hello to all, new to this Forum, recently purchased a Desktop Laser Engraver, from what I see of the pictures displayed it closely resembles a Rabbit mk40, or others that look fairly similiar, has a 30 Watt Laser Tube. Had dramas of getting it to work, because of an inherent fault with the Logic board(which was left up to me to find out- all onus was on me as it left the seller in working condition!??) The seller was very helpful throughout and finally sent me another logic board., took about three weeks of trying various things (all by email instruction only-no phone calls- no number given).
Being an Electronic Technician helped greatly, but should that have fallen on the buyers shoulders??? Now I know for next time.
Well, finally it all worked(apart from a loose contact on a plug which I found and repaired)
So, now we can finally experiment!? out comes the "NewlySeal11" instruction book! written in such appalling English that I cannot make heads or tales of it!!,If I had the knowledge of how it actually was meant to work I would re write it myself, but, because I am new to it I need to read the instructions(which aren't understanable!), and here am I asking if anyone in the know, has already done this task with NewlySeal11, and if so could they share their translation please. Amos