ive been looking high and low for actuators with little luck . i came across these but i have been unable to find any info on them beside what is listed .
the website just confused this noobie more .would these be useable for a cnc mill ? keep in mind ill be using thk linear slide rails with them.i also plan to run gecko drive boards and mach 3 if that matters .
http://cgi.ebay.com/Adept-Linear-Slide-Actuator-2-Units-for-X-Y-Robot_W0QQitemZ170152587203QQihZ007QQcategoryZ55826QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
any info would be great thanks .
cheers
mike

thanks for looking but im going to pass on these shipping is 400.00 thats too much for me .sorry for wasting your time .please remove

So basically that is like a whole X-axis, with both the slides and rails built in to eachother?