Hello, my friend at www.ams-laser.com is willing to setup a DIY site for a laser cutter/engraver, if there is enough interest in it, please reply with your vote, it will be a user donation suported site (not mandatory to acsess) and to start there will be ONE full set of instuctions to build a machine on the cheap. ( less than 3,000 for a 24" by 36"). Her page is in spanish but the diy page will be in english so cast your in the poll tread or e-mail her at info@ams-laser.com

Thanks

Hi mexico redsail,
I have some questions.
- What software does ami-laser use to control engrave/cutter?

Cheers,
Samak

Hello, ams-laser uses either mach 3 or linkmotion for co2