rickst
09-25-2007, 01:20 PM
Not sure if this is the correct forum for this question but here goes anyways!
Our company just purchased several used Fuji (Japan) lathes (TN) and mills (HM-34T).
These machines were set up to be semi automated in the loading process for an automotive OEM.
Consequently they are quite specialized and are not suitable for us to use "as is". Among other things we need to change some of the settings such as the chuck being open on cycle start request.
The settings page appears to be password protected so I can't toggle any of the settings.
We also need to remove/disable the automation interlocks.
We have all the original documentation on these machines, we own Fanuc Ladder III program and are able to down/upload ladder to these machines.
I am looking for advice on how to obtain the password and/or a company or person who knows these controls well who can come in and give us a hand with the ladder logic.
Thanks
Rick
Our company just purchased several used Fuji (Japan) lathes (TN) and mills (HM-34T).
These machines were set up to be semi automated in the loading process for an automotive OEM.
Consequently they are quite specialized and are not suitable for us to use "as is". Among other things we need to change some of the settings such as the chuck being open on cycle start request.
The settings page appears to be password protected so I can't toggle any of the settings.
We also need to remove/disable the automation interlocks.
We have all the original documentation on these machines, we own Fanuc Ladder III program and are able to down/upload ladder to these machines.
I am looking for advice on how to obtain the password and/or a company or person who knows these controls well who can come in and give us a hand with the ladder logic.
Thanks
Rick