Moondog
09-22-2007, 07:03 PM
Hello.
Currently use Rhino3D V4 and wouldn't use anything else.
Looking at using RhinoCam but wondering if Rhinocam supports the following:
1. Turning/lathe module?
2. Bridges/Tabs in the toolpathing?
Look forward to your replies.
cheers
Frans
pointcloud
09-22-2007, 08:20 PM
Yes...
Check out the mecsoft forum. www.mecsoft.com
Moondog
09-23-2007, 01:37 AM
Yes...
Check out the mecsoft forum. www.mecsoft.com
I checked the site...
On the Rhinocam detail/features it doesn't say Turn or Tabs. There is VisualTurn but I am not looking for an additional product...
I even think VisualMill does Tabs/Bridges.
Anybody else know.
Cheers
Frans
chmillman
09-23-2007, 04:25 AM
RhinoCAM does not currently do turning, only milling. I have no idea if or when they will integrate that into the plug-in.
As far as Tabs go, they are not in the current implementation of RhinoCAM 1.0, they will be in Visual Mill 6 (now in Beta), which will become RhinoCAM 2.0. As to when the release version of either will appear, again, no idea... RhinoCAM will be after VM, so I don't expect it anytime soon.
Pointcloud was recommending you visit the MecSoft user forum, it's at http://www.mecsoft.com/phpbb/ --ch
pointcloud
09-23-2007, 11:05 AM
Geesssss I thought I could get turn... I emailed the guys about it.. It shouldn't be that hard to add..