Hi,

Looking for a quote for a total of 6 pieces, 2 each of 3 types.

FacePlate2.dxf is attached.
Cylinder1.jpg is attached. DXF was over 500K, so could not attach it. Will send to anyone requesting. No idea why it was so large.

The third part type is a timing pulley (qty 2) which needs to have the center bored out to a radius of 1.18 inches to fit on cylinder. I have these pulleys on hand and expect to send them to whoever is doing the work. They are Stock Drive Products PN A 6A 3-20DF03708.

Assume you will acquire stock for other pieces unless quoted otherwise.

Thanks,

Dave.

We do alot of alum machining. 6061 aircraft grade. Please send me a drawing I opened the drawing but nothing came through. My autocad is an old version 2000 may be non compatable or something. Send the files to gsilberberg@progressive-plastics.net
Thank you

I have a brand new waterjet cutter. Send the drawing to me at misterpcus@yahoo.com with anything else that's applicable. I'll look at it and let you know what we can do.

Gary

I could import the files, but your "solids" were wireframe only. Was this in Autocad? I couldn't open in 2000. Could you please email files to jjasshipley@insightbb.com I can accept other file types as well if you have them. Thanks for the opportunity

You have a p.m.

Thanks,
Steve

please send files to redgtz@hotmail.com

Thank you! ;)

PM sent.

Could you send files to twilson@ymsinc.net? Would like to quote.