Any body help me with Mitsubishi 60S
When I executed a program from memory, sometime the machine stop(about 1 minute) the xyz axis not run but spindle still run so I must press Cycle start button to continue program.
It issue T01 CAN'T CYCLE START 104( Relate to Feed hold Switch)
T03 BLOCK STOP 0301(Single block switch)

I used to encounter a similar problem on my lathe, although it is running a Meldas50 cnc. My problem turned out to be a bad connection to the spindle drive. It could not return a ready signal back to the controller when the spindle was at commanded speed.