When I load KCam on my Windows 98 Computer it works OK after I set up the motor steps, Pin set ups and so on. I can even cut a part with it.

Tomorrow, when I open it up it will have defaulted back to its "out of the box" settings and will not let me change it !

I will then have to delete the program from the machine and re load it from scratch.

I have ask "Kelly" about this and he told me with BOLD LETTERS, that I need to creat a new machine setup?

I guess every Cow Boy in the country knows how to do this except me ?

First off, I don't know what he is talking about. Second, I don't know how to do it!

Can sombody help me?

When I load KCam on my Windows 98 Computer it works OK after I set up the motor steps, Pin set ups and so on. I can even cut a part with it.

Tomorrow, when I open it up it will have defaulted back to its "out of the box" settings and will not let me change it !

I will then have to delete the program from the machine and re load it from scratch.

I have ask "Kelly" about this and he told me with BOLD LETTERS, that I need to creat a new machine setup?

I guess every Cow Boy in the country knows how to do this except me ?

First off, I don't know what he is talking about. Second, I don't know how to do it!

Can sombody help me?


go to machine then create new machine set up and then save in kacam dir as .ini

Here is a link that will show you how to create and save a new machine setup. Just read the installation manual and follow the instructions. This will help.

http://www.kellyware.com/anonymous/KCAM_User_Manual.pdf