Hello everyone,

I recently made the leap and purchased a Tormach PCNC mill.
I own a Bridgeport 2J and have a good deal of manual mill experiance.
The initial CAM software I was using was SprutCAM however I returned it
because the email tech support was not a realistic option.
Thankfully Tormach refunded my money, (then changed its return policy to no software returns) and I purchased BoBCad CAM V21.
I am using the Mach 3 controller and would like to know if there are any other
PCNC owners using BCC and if so are you using the BCC Mach 3 post?
If I upgrade to BCC 2007 is the post still Mach 3 or is it differant?

Best, Dave

There is someone that can help you over on the CADcAM trainer sight with the tormach related questions.


http://www.cadcamtrainer.com/forums/forumdisplay.php?f=80

Thanks very much for the link, I will look it over asap.
Thanks