Hi,

I recently acquired a very old Makino Vertical Milling Machine, Model: KSAM, Manufacture Date: Feb 1965. Yes..this is really old. I was wondering anyone had any experience with old Makino mill. The wiring is messed up on the back, i have to fix the wiring. i have no clue of the schematic. Any help or your experience is greatly appreciated. I was wondering if it is possible to run using single phase (110 V) using some phase converter.

Hi,

I recently acquired a very old Makino Vertical Milling Machine, Model: KSAM, Manufacture Date: Feb 1965. Yes..this is really old. I was wondering anyone had any experience with old Makino mill. The wiring is messed up on the back, i have to fix the wiring. i have no clue of the schematic. Any help or your experience is greatly appreciated. I was wondering if it is possible to run using single phase (110 V) using some phase converter.

I dont know much about the wiring on the Makinos but I can remember back in the day working on one from the early eightys with a 6M Fanuc control and a BT 50 Taper and what a workhorse it was. Makino still makes good stuff.

Kel1