im using the goaround command so i can create tabs, not using the menu to the side to use contour. how do i make it create extra passes as opposed to one single cut? i could just be blind but is there an option? thank you

set cut depth in define tool i.e. 3mm for a sereis of 3mm deep passes

so if you define the tool as a certain depth you wont have to create extra passes in the options window of the contour as well? if so thats pretty cool. thanks

yup
you tell it the tool wil cut in 2mm passes in cut depth in tool def
then it will only cut a max of 2 mm in one go
if your part is 1.5 mm thick it will cut at 1.5 mm even tho you give a cut depth of 2mm
hope you understand that :-)

thank you