I have an EZ trak sx II mill. After rebooting I am getting an error message stating - Set Parameter (1) failed f4 - error setting Parameter 1.

Does anyone know how to correct this error.

Thank you for you help.

You are booting from a floppy, if your machine is original.
That means your control is about 14 years old. A lot could be wrong. CMOS and or Cmos battery, Floppy drive, software on floppy,logic power supply, etc.
What is in your control?

George

Thank you for your reply. I am booting from a harddrive. I asked one of the electricians to check the x and y switches to make sure they were functioning, and they were. I also copied the BMDC.bin file from my second machine and still no change. I will check to find more infomation on the machine.

Thank you again George.