Can someone post some pictures and a review of their cncbridges table for the X2?
Since the original thread was closed, we can't find out when the tables shipped.
We're interested in finding out how much travel they get and how it performs.
appreciate it.

This link is to an alternate continuation thread:

http://www.cnczone.com/forums/showthread.php?t=41023&highlight=cncbridges

-Mark

Thanks for the link mark, i'll keep an eye on it.
Looks like barry young is highjacking that one too though, same as the original.
A lot of discussion about what he is doing but not so much about cncbridges.
I'll still check to see some pictures of harlows table delivered someday.
Thanks