Hi, it's the first time for me in a forum. But maybe you can help me. I need the acces to optionel parameter on a new Fanuc 0I , but i'm unable to see 9900 - and up. i need to install a 4th axis in the machine.I know i need to change 9900 from 3 to 4 but i dont see these parameter anymore.

How can i see these parameter ?

Best regards

Hi, it's the first time for me in a forum. But maybe you can help me. I need the acces to optionel parameter on a new Fanuc 0I , but i'm unable to see 9900 - and up. i need to install a 4th axis in the machine.I know i need to change 9900 from 3 to 4 but i dont see these parameter anymore.

How can i see these parameter ?

Best regards

Helo ,I think it is in the system parameters ,you pres the buton system not offset there are also parameters to set ,it is the buton under the offset buton .
L.P Boštjan

take a look in the system parameter is the buton under the offset buton ,there are also parameters look for a buton "system"
Regards
Boštjan