|
View Full Version : Mori NV5000 lost X,Y,Z,W zero reference teal854t 08-14-2007, 08:03 PM Hi one of our Mori Seiki NV5000 mill with Fanuc 18i controller lost X,Y,Z,W(tool changer) zero reference position. I need instruction on zero referencing. Thanks Mitsui Seiki 08-14-2007, 09:25 PM What did you do to lose the reference positions?It's easier to help if you know what caused it. teal854t 08-14-2007, 10:57 PM Replaced battery and wasn't connected correctly. Didn't loose any parameter just the zero reference position. Mitsui Seiki 08-14-2007, 11:11 PM So nothing happens when you try to "home" it? Can you run XYZ manually?With the hand wheel? CNC SERVICE 08-25-2007, 09:34 AM PLS CALL SERVICE CALL CENTER ASK THEM THE PROCEDURE TO DO THIS JOB(THEY HAVE PEPER LIKE I HAVE BUT MANY MANY PAGES). THEY HAVE QUITE ALOT MANY POINTS COMPLICATED, ESPECIALLY W AXIS AND Z AXIS IF YOU DO WRONG POSITION IT EASY TO CLASH A TOOL AND SPINDLE. AND YOU NEED TO CHANGE SOME PC PARAMETER TO MAKE W ZRN. I THINK THEY CAN HELP YOU IF CAN NOT GET FROM THEM EMAIL ME AT k_amnaj@yahoo.com. THANKS. |