Can anyone tell me how to add a tool offset bias to this machine?
I would like it to add .500 to the tool offset when it is set

Thanks!

with cursor on proper tool, type "U0.5" then press "Input"

Sorry, I think I asked this question wrong. I have other machines that I can set a bias that every time you set your Z it adds the .500 to the length. I think its a parameter that needs set. If I set up a job w/ 10 tools i dont need to add the .500 to each tool the machine does it when I set the length. I quess I could put a Z-.500 in the work shift, I just didnt know if I could do it another way!
Thanks again!!

Does your control have macro capabilities?
macro A?
macro B?