i need help resetting the shot pin

i sent my tranny out for a rebuild and now i need to reset the shot pin
does anyone have instructions or a manual page that i could look at online or both
it is in a bridgeport torq cut 30 vmc with a dx32 controller

thanks in advance

The shot pin sits on the bottom of the transmission and locks it in either high or low gear. It is spring loaded and air switched by a solenoid retracts it for shifting. It has a switch to indicate its state to the control.
Since there is nothing to set, I do not understand your question.

George

im sorry it wasnt the shot pin it was the trans sw switch that neede to be reset and adjusted i have it all done back up and running

thanks