Is anyone using a FLASH CUT system.

I bought a 3 axes drill/mill and a 3x3 table.

Is it worth geting going, have all the electronic boxes(2) , 3 servo motors, and control cables, but have no software. Is the software available to down load or just to buy, or will any software work with it.

If someone has one and might want to buy, I'll take photos.



Melvin Myers
South Louisiana

How about posting some pictures? Or send them to me via PM.

Thanks,

John

Will get the camera out tomorrow and try to post them tomorrow

Melvin

John,

Just got home and didn't have time to take photos, will try tomorrow.

Melvin

Melvin, are you still thinking you'll post some photo's?

John

John,

I am going to post some photos, got called out (do control panel work)and don't think I,ll ever get back in the shop.
Have nothing planed for Tuesday so maby I can make it happen.

Melvin

John,

Here goes trying to post photos


Mel

42106

42107

42108

42109

42110John,

More photos Will dig out the table and cables this weekend and post them.
Have a few more photos but they seem to be to big to post, will try again.

Mel

42111

42112

John,

Variable speed motor on drill head.

42113

42114

Melvin

flashcut is pretty nice system, you should be able to download the software from the flashcut site if not let me know and ill get it to you

xjdubber

Thanks for the information and offer to help, don't know if I'll get it running or just sell it. I have so many projects going on time is tight.

I will ost some photos of the table by the weekend.

Melvin

Here is the link to the Flashcut site where you can download the drivers software. http://flashcutcnc.com/html/dow.html

Download 2.1.4 Live version and install it.