Hello,
I am thinking of buying a K2 or other small router for cutting 3.2mm aluminium. Does anyone have any recomendations? I am not planning on doing production work, I just need to make prototype parts to speed up the design to release cycle. I would especially like to hear from anyone in the Glendale-Phoenix area.
Thank you.
Roger

Roger,

This forum doesn't see a lot of action. You might have better luck finding a person in your area by contacting K2 directly. They might at least pass on your email address to a few customers. I have the 3925 and it works great for extremely hard woods, but I haven't cut any aluminum yet. However, I did accidently rout right through a steel nut one time with no problem at all.:)