I'm a complete newbe to CNC and I was then thinking of something small as my first CNC machine, then this add popped up...


Tree 300 Journeyman CNC/Manual Milling Machine
10X48 Table Size
High Low Range 4200 RPMS
Weighs 5,400 LBS
Box Ways
RS-232 port
220 Volt
Updated to use mastercam or other programming software
Not under power
$3000.00

http://tumalo.org/catskin/Tree.jpg


Should I run out and buy it?

I'm a complete newbe to CNC and I was then thinking of something small as my first CNC machine, then this add popped up...


Tree 300 Journeyman CNC/Manual Milling Machine
10X48 Table Size
High Low Range 4200 RPMS
Weighs 5,400 LBS
Box Ways
RS-232 port
220 Volt
Updated to use mastercam or other programming software
Not under power
$3000.00

http://tumalo.org/catskin/Tree.jpg


Should I run out and buy it?


I purchased this machine and it now sits in my garage. The spindle does not work but shouldn't be too hard to fix.