FEATURECAM 2007

Does any one have a post processor for MACH3?
But it has to be for metric system
Please share it.

I have one. Metric or English shouldn't change anything. I wrote this one mind you, it outputs code the way I program a Fanuc 6m. I like all my programs to look the same.

I have not actually used it yet, I would throughly check the canned cycles codes before running them. The code looks good though. Gotta watch for codes that Mach doesnt support. I am going to mod it to run Mach3 Lathe next time I need it.

The post processor is easy to change if you don't like it. Email me and I'll send it to you.

Whiskeybravodelta at comcast.net