When our SL10 and SL20 get really busy, the TL1 often gets us out of a jam by taking care of the odd small lot orders. This job required no manual tool changes due to the gang toolholder. Anyone else?

http://i146.photobucket.com/albums/r247/gearman22/TL1/th_313235.jpg (http://i146.photobucket.com/albums/r247/gearman22/TL1/313235.jpg)

Even with the toolchanger gang tooling is sometimes needed and for large parts it is a juggling act. First two pictures show five operations; drill, bore, turn OD, thread ID, thread OD with the drill inside the hole. Third picture shows two mating parts done with a total of six tools. I have used up to eight tools but three of them were spot drill, drill and tap so that was not too complicated.