Do any of you guy's have any circuit diagrams or pin config for the Randtronics drives in an MB1?

Thinking of retro-fitting and just wondering if it's feasable to keep the old drives?

Dave

I have done a couple of retros on Hurco's using Servo Dynamics in Chatsworth CA sweet gal named Lillen can help you (818)700-8600

i have the original servomate service manual. it's a 14 megabyte PDF so i can't upload it here. PM me your email addy and i'll send it to you.

Can I get a copy of that PDF file as well?
Thanks,
Brett

bmachinist,
sure, i can give you a copy of the PDF, but the file size is over the limit of what this site allows. Email is the only way that I can send it.

Can I have a copy as well. Just what I've been looking for!