Just wondering if there is any news? I got my new Autodesk box in the mail.

I wonder if a new hypermill is coming to support the current Inventor?

So far 367 people have viewed this thread! There is lots of interest here.


Cheers
SF

hyperMILL 9.7 will include support for Inventor 2008. It is expected in Q4 07.

The lag after Autodesk's Inventor release is not really due to hyperMILL in Inventor at all, but more that our resources have been highly focused on hyperMILL 9.6 that should be released quite soon. Of course, 9.7 follows 9.6.