|
View Full Version : Phoenix-EZ Big Stick 04-23-2007, 12:27 PM I am looking for a program which I did not receive with this Lathe. The company went out of business and now my search is on. Magnum Tech built these units. it has a 36 in Between centers and the tech spec is HQL-EZ mrdealer@ptd.net would be a big help. iamthesnakeman 08-14-2007, 07:04 PM Got a lathe through a school no programs but a computer that just plain died after about an hour,still trying to get a boot out of it.Older than dirt,hard drive connected to a interface. old wired battery.i will stay in touch as it progresses. Iamthesnakeman bkkpool 10-08-2007, 10:38 AM Can other programs be used to operate these lathes? Pierre A 11-03-2007, 01:26 PM I work in a School that has a phoenix-ez we got it retroed at red-cam We can now use it with master cam. you will find them at red-cam.com they are good iamthesnakeman 11-04-2007, 02:48 PM Thanks for the info. Looking forward to getting this lathe going Thanks Iamthesnakeman |