Got an MB1 that's got problems.

It has been sat for a while, haven't had the time to work on it.

Put a new encoder on the other day and cleaned out the carbon dust from the motors, a previous fault.

Tried booting from disc as normal, gets to the choose language screen and then nothing happens when you choose 0 for English or any other number.

I have tried removing/refitting all the plugs and wiring but still the same.

Any one out there had a similar problem?

Dave

Try these guys....I use them and he is real good...nothing but hurcos.....free phone support. http://www.midwestcnc.com/page4.html

Jim