My surfcam editor quit working. This was caused by an update to windows. I uninstalled the last 5 updates and it started to work again.

yea happened to me too, on a couple programs.. if the error you were recieving was this:

The system DLL user32.dll was relocated in memory. The application will not run properly. The relocation occurred because the DLL C:\Windows\System32\Hhctrl.ocx occupied an address range reserved for Windows system DLLs. The vendor supplying the DLL should be contacted for a new DLL.

then do this hotfix (http://support.microsoft.com/?kbid=935448)

hth

The hotfix worked great Thanks:)

Solidworks 2007 to surfcam 2004