Hi,
I use Mach3-Profile from SyilAmerica. I will calibrate the machine. Go to Settings-Tab and click the "Set Steps per unit"-button, write down a value e.g 5. Here come the confuse, is the value 5 in mm or in inch. click OK and the machine moved in the right x-axis. The dial moved from pos 0 to 16.5 (x 0.01mm). Anyone can help me? I will work in mm. I think the x-axis move 5mm if I write 5...? (Sorry, my English is limited):confused:

Hello Ata..

We have a Mach3 profile setup for MM.

Can you send me an email at info@syil.com.au and I will send you the Mach3 profile.

I assume you have the X3??...

cheers

Frans

Syil Australia

thanks frans.

also,it is have download in syilamerica.com too.

xushuo

HI

My name is Manoj, I am also using Mach3 & bit newer to the parallel port connection.

Can i request any support

I want to control 3 stepper motors, I am having stepper drive.

Regards
Manoj

Hello Ata..

We have a Mach3 profile setup for MM.

Can you send me an email at info@syil.com.au and I will send you the Mach3 profile.

I assume you have the X3??...

cheers

Frans

Syil Australia

Can you send me an email at info@syil.com.au and I will send you the Mach3 profile.


Hi Frans,
I sent you my email to info@syil.com.au yesterday.
Thanks.
Ata