Index arm open ?????//

--------------------------------------------------------------------------------

Anyone know what this means???
I went to tool change and notice that I get this error.. Also I notice that the lines at the control show the same for about four or five instances.. The program is fine but the control must be referencing an alarm..
Like an idiot I had the air off.. I have since gone back and re cold started the machine.. Still have the same problem.

I did put in an old program to disprove any program claim..

Cheers Chips

Chips--
Ae you sure that you are refering to a Fadal machine? I know of no alarm message with that syntax!!

Neal

Neal

Ended up being an issue with the M8 coolant..

I had my servo coolant callout and it didnt like it.. (M8 L4.1)

Got rid of the L4.1 and all is fine..


Chips

Chips--
I'll have to add that one to may error banks. I had never run across it before. Just goes to prove that no matter how much you know, you can always learn more!
I couldn't even find that error message in the manuals! Thanks for the lesson!!
Neal