rimcanyon
03-23-2004, 11:26 AM
I have a pair of Slo-Syn 3180-PI motor controllers (programmable indexers).
The manual lists L codes and H codes for program control and N,G,X and F codes for motion programming and has some examples. Will BobCad be able to talk to this controller and generate all of the codes mentioned? Is it just a question of properly configuring BobCad?
I'm a newbie, so basic information about this particular interface (CAD/CAM <-> different controller capabilities) would be much appreciated. Even some pointers as to where to learn about it would be great.
Dave
The manual lists L codes and H codes for program control and N,G,X and F codes for motion programming and has some examples. Will BobCad be able to talk to this controller and generate all of the codes mentioned? Is it just a question of properly configuring BobCad?
I'm a newbie, so basic information about this particular interface (CAD/CAM <-> different controller capabilities) would be much appreciated. Even some pointers as to where to learn about it would be great.
Dave