Dear all .
I'm Hung from Viet Nam. I have a milling machine CH-VMC 500 with S/N 04025001.
This machine use Mitsubishi 60S Controller.
Now this machine is not working, it indicate error "NO PLC". The Spidle or axes can not move.
Please help me to solve this problem.
Thank you for your support.
Best Regard.
--
Viet Hung

Sounds like the ladder needs re-loading. If it is not on disk, it would have to be loaded manually.
Al.

Thank you very much!
Please show me the way to check the ladder Plc file if it is on disk.
Show me the way to re-load step by step please. I have not document.
Best Regard.
Thanhct.

The Mitsubishi site has all the manuals MEAU.COM
http://www.meau.com/Files/BNP-B2269.PDF
Al.

Thank you for your support ! I found document BNP-B2269

I need help again !
I read the manual about Mitsubishi M60 and I known it doesn't hard disk. I found memory cassette:FCU6-HR451 for maintenace.
The manuals show me the way to backup and restore parameter but
I can not find the way to restore PLC program.
Please help me !!!
Best Regard .
-------------
Thanhct.