Hi all,
I purchased a Bridgeport with a 3 axis Crusader M controller. Just got it up and running and was trying to do a simple circular pocket with G77 canned cycle. The program will do the outer circle and not step in to finish the pocket it will just keep travelling around the outside. I tried the rectangle pocket also and it does the same thing?

I am putting all the V codes just like the book says. Not sure what the problem is.

Thanks

I don't have a Crusader but I have an Anilam 1100. Are you sure your not doing a circular profile instead of a circular pocket...

John

Hi Scottmi,

Have you figured this out yet? We use to have a Crusader M but it died on us. We still have the manuals. I looks like V45 is Max Incremental step over, V46 is Max depth of cut, and V47 is Stock left for finish. V50 is 0 for finish cut or 1 for no finish.
Maybe this will help.