Howdy

I wanted to make a place for anyone that has information/questions concerning the cnc mills that were (are) aimed at the education market

Light Machines Enco D@M Benford Rhino Lab Volt Most are older with good iron, but quirks unique to each.

I have a Rhino ST6 Lathe - a demonstrator left orphan when Lab Volt took them over.

A D@M 6 Mill that was replaced by newer enco stuff.

The Lathe is living on the borrowed time of a windows 96 computer with an active search for an xp based control.

The D@M is in the process of getting "modernized" with help from

Conqueror Design and Engineering Limited http://www.eaziform.co.uk/phpwcms/index.php?welcome

in the form of an internal controller card and updated control software.

Well - good luck on your cnc adventures