I am not able to configure in the right way the G-post for Mazak Integrex 1060.
Could someone tell me if it is available a download site to get one copy of it??
I would use it under Pro/Wildfire 2.0 or 3.0.

Thanks in advance
Massud

i am not aware of any free posts out there, but if you find one i would like to know too.

If you have a active maintenance agreement with PTC you can download a few free Postprocessors from their websites here: http://www.ptc.com/cs/cs_23/howto/ncgp4903/ncgp4903.htm
Requires a password though.

Theese are often more easy to modify rather than writing one from scratch.
Other than that I think you will have to pay up to get one custom made, if you dont find a kind sould that has the same setup as you.

Best regards, Jonas